![]() Repeat steps 1-4 for reach additional quick connect.Be sure to press the terminal to lock it over the metal tab in the end of the plastic quick connect. Insert the quick connect terminals into the plastic quick connects, matching the positive (red) lead to the positive side of the quick connect and doing so the same for the negative (black) lead.If there is any excess copper wire outside of the terminal, isolate it with electrical tape. Driver Recovery Products quick connector set gives the user a simple, convenient way to connect and disconnect power to winches and other electrical devices. Provides simple and convenient method for connect/disconnect power to a winch or other electrical device such as remote battery chargers, power inverters, solar setups,trailers, or for any purpose requiring a high-current, quick-disconnect connector. Crimp end of the quick connect terminal to ensure the copper lead does not separate from the terminal. About this item UNIVERSALHeavy-duty & multipurpose universal battery quick connector set from Driver Recovery Products. Insert as much of the wire in the terminal as possible to prevent any power loss when using the winch. Slide the bare copper wire into the metal quick connect terminal.FREE delivery Fri, Jun 9 on 25 of items shipped by Amazon. When stripping the insulation, be careful not to cut the proper wire. Spurtar 50A 6-12 AWG Battery Quick Connect/Disconnect (2 Pack) Wire Harness Plug Connector Recovery Winch Trailer / 12-36V Battery Terminal Connectors/Quick Disconnect Wire Connectors Gray. ![]() Remove approximately 1' off the insulation from the battery lead. View our inexpensive range and high quality range of Quick connect release positive and negative car battery terminals. Strip the insulation off the copper wire at the installation point.Cut the cables in the same spot to maintain similar lengths for both positive and negative leads. Cut the positive and negative leads at the location where the quick connect is to be installed.If installing only one set of quick connects, be sure to install on the positive and negative leads that attach to the battery.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |